Stained Glass Info
use clear contact paper


Cut glass to fit your pattern
(Remember it's easier to cut glass on the smoothest side)
This may result in reversing your pattern piece so always 
check to make sure you've got the right side down on your contact paper

**You want the side you want to see as your finished product face down 
on the sticky side of the contact paper

Lay out glass on contact paper.
Lay a copy of your pattern under the Clear contact paper so you can follow the pattern easier.
Put a light coat of mold release agent on the mold. Place contact paper with glass in mold.
Gently wipe off glass with alcohol or nail polish remover to remove any excess oils.

The concrete Mix is:
3 (16 oz can) Sand
1 1/2 (16 oz can) Cement
Approx. 1 (16 oz can) Water

Make your mix about the consistency of Tomato paste
Gently work in the sand base mix between the pieces of glass.
(if you want to add aggregate in your mix do so after about 1/2" of sand mix making 
sure your sand mix is:
NEXT TO THE GLASS

Finish filling the mold, leaving about 1/8" from the top of the mold.
Tap mold as you would a cake to remove air bubbles.

Let set approx. 24 hours
Concrete dries best at temperatures above 70 Degrees F

After removing the mold, peel off the contact paper and gently clean off the residue
with a light steel wool and a damp cloth

If you want to add a  concrete sealer to your finished product that's okay except:
it dulls the glass. So then you can use nail polish remover to clean the glass.

Enjoy!